Need help/info on Navy Mark IV high altitude helmet parts identification...

dogstar

Member
These helmets have two gizmos attached to the back of the helmet...on the left rear, it is a black item made by Farwell Co. which I am guessing is an Oxygen adjustment vlave and connection...also, on the right, what appears to be an adjust ment dial? perhaps for the radio volume? Any help with id and nomenclature, measurements would be greatly appreciated...thanks!
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top