Graflex with 3D print chassis from Graflex Saber

GraflexSaber

GraflexSaber

Member
RPF PREMIUM MEMBER
MB_sabers_Shapeways_banner_05.jpg

My Graflex Chassis works with most bladeholder (TGS, SH, KR) and most soundborads (Plecter, NEC).
Also there is a version for 18650 cells and one for 14650 cells!
It is designed for vintage and similar replica Flash Tubes.

You find a manual and more informations on my homepage mb-sabers.com

This is a setup with SH blade holder, CF 8, 2x14650 Li-Ion cells, 28mm 2W bass speaker, crystal chamber and plasma gate!


09.jpg12.jpg
18.jpg17.jpg

Now there is also a version available for 18650 cells. And this is removeable!
Take a look:

18650.jpg3D chassis_18650_02.jpg

Shapeways link to my chassis-parts SHAPEWAYS
For more informations and send me a PM or check my facebook page https://www.facebook.com/GraflexSaber/
or visit my homepage MB-sabers

thanks for your interest
 
Last edited by a moderator:
I'm slowly working on collecting all the parts I'll need for this.

I've got your 18650 assembly kit and laser cut fins. Next is getting all the 3D printed parts and getting to work!

Already have all other needed electronics, KR bladeholder, etc.

I'm sure I'll have questions as I go about assembling everything.

Any advice on where to find such tiny gauge wire?
 
I'd love to upgrade my Graflex 2.0 to this chassis but I don't have the time and I'd have to pay someone again is the assembly easy?
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Lovecrafty
Graflex spring help
Replies
2
Views
193
Lovecrafty
Lovecrafty
Corellianexports
Empire Strikes Back Dak Ralter Helmet Build
Replies
11
Views
1,157
CatfoodRob
CatfoodRob
R
GRAFLEX REPLICA GUIDE???
Replies
5
Views
535
Ridire Firean
R
FLS89
Vintage Graflex from my childhood
Replies
17
Views
1,250
Anakin Starkiller
Anakin Starkiller
Raaven1990
How durable is a DIY Vader saber with 3D printed parts?
Replies
15
Views
608
SPY007
S
Back
Top