Archive&Future
Sr Member
An exciting new commission, it's good to have another shot at this beautiful design after my own attempt never got off the ground.
Diameter of the final ship will be 325mm, bringing it into scale at a pleasant 1:200th
I began with
1mm styrene cut to shape according to my blueprints, then chamfered it for a snug fitDiameter of the final ship will be 325mm, bringing it into scale at a pleasant 1:200th
I began with
Panel lines scribed using a steel rule and sharp centre punch, the thermal shielding is 100gsm linen texture paper
A sparing coat of Tamiya Ultrafine primer hides the imperfections
Retro-thruster blocks scribed and then drilled out with a curve tapered dremel bit
Another 1mm styrene shaped cut to frame the engine thrusters. Since there are four of these thrusters modules, I'll be moulding and casting this master module
Last edited by a moderator: