I have been working on a project since December and I keep running into hurdles.
My Latest is the mold I made is out of OOMOO 30 Tin Cure Silicone and the Puppet I want to make needs to be Ecoflex 00300. I have a stop motion armature that will be inside the puppet.
I bought inhibit X but want to make sure I know that I'm using it right before I commit my last bit of silicone for it.
I saw a tip to pour inhibit x in the mold and then pour it back out and let it dry for 20-30 min.
I was going to try this but didn't know if I should spray mold release before or after I did this?
Also, how exactly does inhibit x work? Is it a one time treat and be done or will I have to reapply it every time?
Thanks
My Latest is the mold I made is out of OOMOO 30 Tin Cure Silicone and the Puppet I want to make needs to be Ecoflex 00300. I have a stop motion armature that will be inside the puppet.
I bought inhibit X but want to make sure I know that I'm using it right before I commit my last bit of silicone for it.
I saw a tip to pour inhibit x in the mold and then pour it back out and let it dry for 20-30 min.
I was going to try this but didn't know if I should spray mold release before or after I did this?
Also, how exactly does inhibit x work? Is it a one time treat and be done or will I have to reapply it every time?
Thanks