3D-printed 2.5 Inch Millenium Falcon

Kyuzo

Active Member
print.jpgphotgram6.pngphotgram5.pngphotgram4.pngphotgram3.pngphotgram2.pngphotgram1.png

Very happy. Not very experienced 3D-modeller so the model is a bit of a mess polygonwise. It's a bit off here and there. Also got the bandai 006 today which is huge.


Thanks for looking.
 
My pleasure! Hope you like it. I'm planning to do a version 2.0 when I get the time, as I found some reference photos with better resolution.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top