10:1 scale loveheart sweet.

pandabarnes

Active Member
Firstly, apologies for the cheesy valentines related content.

This thread follows on from my earlier thread http://www.therpf.com/showthread.php?t=244624

Lucky for me minifig was kind enough to help me out on the materials front, thanks man, and I had another more successful go at this project.

So, this is a loveheart sweet, scaled up x10, made from low density pu foam. I wanted to take it a bit further, but my GF is now refusing to surrender it back into my care for distressing, filling and proper painting.

loveheartfront.jpg



loveheartback.jpg

Size comparison.

loveheart.jpg

I'm quite happy with the results, if a little annoyed that I didn't notice the text was a bit out until it was too late to fix - I used the text template from my first attempt, and had somehow missed it then too!
 
Last edited by a moderator:
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top