3d Printing a Robocop Suit

filament is in. Printing the fingers for left hand with what filament was left. one of the finger joints frizzled so I will have to reprint it. Out of town for work so I havent been on. progress resuming!
 
reshaped the grips on the Auto-Nine, I wasn't happy with the size or flaws in it so here it looks now. compare to earlier, I think its much better. Hard to tell from sides but the grips were very thick, was imagining what it would be like to hold with gloves. IMG_0596.jpgIMG_0597.jpg
 
Robocop was my favourite movie growing up, really loving the look of this build!
Full suits are a long slog with 3D printers but well worth it in the end. Can't wait to see this finished.
 
Printing the left shin. Having to rethink print layouts for back torso and resizing the fingers. They are just too small. Shin is a 3 parter. Pics to come!
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

M
HELP WITH PRINTING ON FABRIC
Replies
2
Views
419
MandusZz
M
F
Cyberpunk 2077 Trauma Team full costume - minimal printing
Replies
0
Views
149
Frankted
F
Galia dude
Making a Lunar Space Suit (For My Space Program)
Replies
0
Views
124
Galia dude
Galia dude
Djh69
Bruce Hansing Robocop suit question
Replies
3
Views
1,846
streetjudge79
streetjudge79
Pok Props
Helldivers 2 Suit.
Replies
2
Views
366
Pok Props
Pok Props
Back
Top