M19 scope details

xx1180

New Member
I am wanting to make my own M19 scope on my lathe and milling machine can someone please tell me the right dimensions of the real scope so I can make it as accurate as possible thanks
 
Last edited by a moderator:
Maybe you could PM Field Marshall and ask really nice if he could share some measurements.
 
My advice...get a good resin M19 for reference and start from there....just looking at pictures and having the basic measurements won´t be sufficient, since the shape is pretty complex
 
My advice...get a good resin M19 for reference and start from there....just looking at pictures and having the basic measurements won´t be sufficient, since the shape is pretty complex

the problem is getting an accurate casting that is why I am needing the measurements from the real scope
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top