Metal casting service recommendations?

Thread starter Zoidoid
Start date Jan 21, 2017

Zoidoid

New Member

Jan 21, 2017

Hello! I have some relatively small pieces (we're talking 0.07 cubic inches of material per) that I have modeled in SolidWorks and prototyped using desktop 3D printers. My intention was always to get bunches of these cast by sending out the 3D file to a service that could cast them in brass or bronze. That being said I'm having a hard time narrowing down the options. Sooo...

Can anyone here recommend a casting company? I'm considering some jewelry casters as well to see if they'll take pieces that aren't standard wearables. Also if the company/service happens to be in the New York City/Tri-State area that would be even better. Thanks in advance!

Last edited: Jan 21, 2017

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.