Correct.
Awsome, I thought my esb mpp was complete until I read this. Thanks for helping me finish it. Also, I already have a few of your cards on my sabers, great products.
Correct.
Awsome, I thought my esb mpp was complete until I read this. Thanks for helping me finish it. Also, I already have a few of your cards on my sabers, great products.
The ones I will provide are card only. You'll have to source the bubblestrip elsewhere.
That all depends on what people agree should be made first. Eventually, if sales are good, I can justify doing other colors, but I'd like a consensus on the "most wanted" color first.
Ok folks, finally got some progress on this layout...
http://www.slothfurnace.com/images/clampcard/slothfurnace_mpp_card_01.jpg
Those thin lines are at 0.01 inch, very thin. I've had my digital calipers all across this thing very delicately, as to not scratch up the sample. Trying to be very careful with it.
Will adjust a few things tomorrow, but that's my first crack. Holes in the middle pads down the center are every 0.25 inch.
Seems like the card is pretty wide, might not need that much real estate, but not sure yet. Right now it's as wide as my normal cards at 0.625 inch.
Ok folks, finally got some progress on this layout...
http://www.slothfurnace.com/images/clampcard/slothfurnace_mpp_card_01.jpg
Those thin lines are at 0.01 inch, very thin. I've had my digital calipers all across this thing very delicately, as to not scratch up the sample. Trying to be very careful with it.
Will adjust a few things tomorrow, but that's my first crack. Holes in the middle pads down the center are every 0.25 inch.
Seems like the card is pretty wide, might not need that much real estate, but not sure yet. Right now it's as wide as my normal cards at 0.625 inch.
Ok folks, finally got some progress on this layout...
http://www.slothfurnace.com/images/clampcard/slothfurnace_mpp_card_01.jpg
Those thin lines are at 0.01 inch, very thin. I've had my digital calipers all across this thing very delicately, as to not scratch up the sample. Trying to be very careful with it.
Will adjust a few things tomorrow, but that's my first crack. Holes in the middle pads down the center are every 0.25 inch.
Seems like the card is pretty wide, might not need that much real estate, but not sure yet. Right now it's as wide as my normal cards at 0.625 inch.
There is a further darker colour nearer a tan too. If I get chance and if I can find them in the house at the moment I'll post a pic of the various colours I have.I've got another weird color:
https://uploads.tapatalk-cdn.com/20170118/307bc2e6e526ea4801ccdfdaead08b07.jpg
I have two of those, from Exactras 20.
The bubble strips have two additional bosses going in the small holes.
@Sym-Cha I've filed the edges of my strips to a taper like that to make them fit in graflex clamps, so I'd say it's entirely possible.
It's possible they only filed a bit from the front of the bubblestrip lengthwise just enough to slide the rest in more easily, because one can see the edge of the clamp teeth almost midway to the end of the cut-off bubble as seen in the third picture above :wacko
Chaïm