BSG Tool Box, looking for tips on labeling

Sulla

Sr Member
RPF PREMIUM MEMBER
Found an old Dewalt case my dad wasn't using that was used as a BSG tool box.

I was wondering what you might use to create the labeling?

I was thinking about the following:
  • Drawing up the letters and having them printed on adhesive backed vinyl.
  • Making a stencil and paint the label.

31411361384_c09c5496fc_o.jpg
 
I'm with you I'd be stenciling with a vinyl mask ... there's ebay sellers that will cut your designs for next to nothing. I'd offer to supply but shipping would cost more than the vinyl haha

Sent from my SM-G900F using Tapatalk
 
However I will try and source the font and may be able to provide you with the vector file

Sent from my SM-G900F using Tapatalk
 
Last edited:
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top