Marksman-H combat remote (floating)

Well, Profezzorn's resin print seems to get better resolution that I'm getting from the FDM prints. I'm reworking a few of the bits I'd printed because the walls were too thing (I think just barely) and didn't print very well. I'm getting close, thanks Prof for the files!
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

MartinSivertsen
Jedi Training Remote - Floating With Lights - Custom Resin 3D Print Build
2 3
Replies
44
Views
5,537
PHArchivist
PHArchivist
S
Another Floating Remote Base
Replies
13
Views
2,213
Sherman Archibald
S
Darth Terminus
Jedi Training Remote - Stand Needed
Replies
4
Views
862
jedi5150
jedi5150
Imagehunter
Need ideas for a Marksman H seeker droid.
Replies
5
Views
944
Imagehunter
Imagehunter
Fuzzual
Trooper Trent's Marksman-H Display Case
Replies
14
Views
1,723
Fuzzual
Fuzzual
Back
Top