KrangPrime
Master Member
I'm not sure i'm feeling this one. how does this look? minus the trap stripes.
Real Ghostbusters...
- Thread starter KrangPrime
- Start date
KrangPrime
Master Member
http://www.thingiverse.com/thing:1944165
That'll be it untill we start seeing how some of these things print.
That'll be it untill we start seeing how some of these things print.
KrangPrime
Master Member
In a bit, will start on the tougher proton pack. one quick change, shortened the handle
KrangPrime
Master Member
Please LMK if anyone tries to print these suckers.
I'm real curious to see what people can do with them.
And it'll be that much more incentive to do more.
Like a Scaled down RGB Containment unit to go with the proton pack
I'm real curious to see what people can do with them.
And it'll be that much more incentive to do more.
Like a Scaled down RGB Containment unit to go with the proton pack
KrangPrime
Master Member
you can thank two hours of cbs fm christmas music. didn't feel like going to sleep or working on turtles 
2.5 hours later.. all the detail is ther.e now just a matter of shaping it
also fixed the trap doors
2.5 hours later.. all the detail is ther.e now just a matter of shaping it
also fixed the trap doors
Last edited:
KrangPrime
Master Member
doesn't really look right yet, but it's a start.
with toon ink turned on
with toon ink turned on
KrangPrime
Master Member
that's looking a little nicer..it for the night
KrangPrime
Master Member
not feeling the proton gun yet
most of the main body detail is there.
Compared to the movie Proton pack i never finished.
most of the main body detail is there.
Compared to the movie Proton pack i never finished.
KrangPrime
Master Member
did anyone bother to print these to try and see how they look finished?
KrangPrime
Master Member
well, even if no one bothered to try and print them ( I might send one out to shapeways this year)...
I'm almost done with turtles.. so taking a few das break this week and will try to finish up the proton pack. maybe even start on an egon to go with him.
I'm almost done with turtles.. so taking a few das break this week and will try to finish up the proton pack. maybe even start on an egon to go with him.
KrangPrime
Master Member
3D printable and ready to roll..maybe i should send one out to shapeways.
KrangPrime
Master Member
So would I
did anyone take the time to try it?
I'd love to try and print the parts in metal through shapeways, but even in pieces it'd probably be too expensive.
did anyone take the time to try it?
I'd love to try and print the parts in metal through shapeways, but even in pieces it'd probably be too expensive.
