deleted

Hello, folks! Still working on progressing with the modifications of my suit build. I've redone the leg joints so wanted to share that as well. Testing it out has worked pretty well so far. I'll be making some slide mounts for the cuisse (thigh plates) to fit over them. The idea is to have something that will hold it in place, and be completely covered by the costume.

https://www.youtube.com/watch?v=j_ZGhQIQeEQ&index=3&list=PLHo7jv85Yc7TD6sox5C5LPb0cKO5iDKKI

Hope this helps give people ideas and I would not be against ideas myself. Still working on arms and helmet, but should have the helmet assembled some time this week. For Russ!

P.S.: Apologies for camera quality, I'm working with what I have available.
 
Nice work. I recently came across those same lazy susan bearings at a local shop and immediately thought of them for shoulder joints. Awesome to see that they do the trick! Good luck moving forward with your build.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top