Harley Quinn hammer build

spartan1803

Well-Known Member
Hey guys, long time no post! Well here is my progress so far on the hammer. I got the tamplet from a video on YouTube. It belongs to a builder called "Jack of all" I believe. I'm extremely happy with this build given the fact that all my attempts at foam project haven't panned out or look like crap. So without further ado... IMAG1512.jpgIMAG1514.jpgIMAG1515.jpgIMAG1519.jpgIMAG1522.jpgFB_IMG_1476840287362.jpgFB_IMG_1476840301168.jpgFB_IMG_1476840308378.jpgFB_IMG_1476840329552.jpgFB_IMG_1476840372073.jpgFB_IMG_1476840383379.jpg

I had to sand down the tops, I didn't heat form the panels enough for them to fit. After work today I'm going to start painting!!! Look for more updates later!

P.s. yes that says Harley Quinn and Deadpool ;)
 
Amazing what can be done with foam! Keep it up!!

​~ I Athena I
 
Last edited by a moderator:
Thank you! The paint was still a llllittle tacky this morning. Hopefully after work I can start taping and start with red paint
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top