I know it dose not seem like much but Im sure you understand the importance, After working on it Im ready to export it to 360. I have it scaled to about .4mm percision, still a few bumps and what not that are not on the helmet but its good enough. To scale it I took a bunch of measurements from the scratch marks to scratch marks and side to side to ensure its scaled, Next is building an over lay that I can cut out the shape of the armor.
Im just So excited it worked, this was my second attempt the first was not so good had holes and weird stuff going on.
Back to Design of the holes on the right side of the helmet(if you'er wearing it) re lego man and card. I see 4 small vertical rectangles on top and one hole the same size as front holes but with the middle filled in so you only get each side of the rounds. Im not sure if all the helmets have all the holes/vents? Looking Thain's pics on page 10 you can definatly see them and they are quite small on the top, and on one there are more than one lower hole. For the time being I will plan on making 5 holes (4 top and 1 at the bottom split).
Sleep well. I know I will be planning in my sleep dam it.