Quick Pepakura Designer question

M

Mustard Tiger

New Member
Hi guys, not sure if I am posting this in the right place.

Just wondering, does anyone know if there is any way to search for an edge ID within the 2D view?
I ask as I am currently working on Fierfeks Vader armour and am spending 90% of my time trying to find tiny little numbers! Haha!
 
Hi MT,

by right-clicking on your overview on the right side you will find an option that says something along the lines of "Check corresponding faces" .You can use this to ID your parts,and where they should go is now indicated by a thick,red arrow pointing at the corresponding part.I hope this helps you.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

cricketcos
Mask Material Question
Replies
1
Views
339
kickman88
kickman88
kdub74
Mask Making Question
Replies
3
Views
580
Mottrex
Mottrex
DrStrangelove
Mold release question.
Replies
3
Views
763
udog
udog
S
Building up silicone mold question
Replies
2
Views
692
scorpia777
S
Hecubus114
Question Regarding Chavant Clay...
Replies
2
Views
658
weaselflinger
weaselflinger
Back
Top