Trick R Treat Sam

Dcrutchleo

Dcrutchleo

New Member
Hey everyone. I need a little help. I'm getting ready to start a couple of static Sams, possibly poseable if I can do it fast enough. Does anyone have the dimensions of his head, body and overall height? Thanks in advance.

c58ca70f81b4344b633c8365e4a6c766.jpg


Sent from my VS986 using Tapatalk
 
Exact behind the scenes info would be best but, failing that, you could get pretty close based off typical jack o' lantern-sized pumpkin measurements at your local pumpkin patch.


Sent from my iPhone using Tapatalk
 
I thought about that but it still looks too small. I was planning on making it out of foam or plaster.

Sent from my VS986 using Tapatalk
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Rusty85
Trick or Treat Studios SAW Billy the Puppet Deluxe Prop Replica
Replies
4
Views
567
Rusty85
Rusty85
StaggzCosplay
The Creature Walks Among us: Trick Or Treat Studios repaint
Replies
0
Views
603
StaggzCosplay
StaggzCosplay
Media Man
Tricks to unclog spray paint cans?
Replies
1
Views
178
TazMan2000
TazMan2000
L
Trick or treat Gremlin prop sealant
Replies
0
Views
427
Lawton81
L
Runner
Tricked out Tricorder!
Replies
2
Views
631
Apollo
Apollo
Back
Top