Planet Replicas Lawgiver 3D Print files... How to orient them!?

bolsoncerrado

Well-Known Member
Anyone succesfully printed these files on FDM at home/work? WIth a desktop machine I mean, not a $40k one lol

I have serious wonders on how to place certain parts on the bed for optimal printing, specially the curved body parts...

Anyone?

Thanks!
 
I've printed this and I get your wonders. There are some pieces that just have to get printed with supports but you can orient them so that the supports are printed on surfaces that are easily cleaned up or not seen.

I've sucessfullly printed this on a Rostock Max V2 at home.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top