Made a Pan / Rufio sword template, need cutting advice

AJLoCascio

AJLoCascio

Sr Member
Hey guys - Need a bit of advice here - looking to get this pattern I made cut in aluminum, plastic or wood. Located on LA & need it within the week. Open to suggestions!

Feel free to use the template. The blade length is 22" from what I can tell; not including the tang.

Cheers!
-Moony

Pan_Sword.png
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

CreechMagoo
On the hunt for an accurate medieval sword
Replies
17
Views
771
Gold
Gold
DaBuild
Rita's Sword: Edge of Tomorrow (all the files)
Replies
11
Views
1,446
DaBuild
DaBuild
AgentZero
Advice on "straightening my sword's edge"
Replies
1
Views
413
Moviefreak
Moviefreak
Indy Magnoli
NEED HELP: Font Finders ?
Replies
10
Views
312
rjenkinsgb
rjenkinsgb
ZadeWilson
BIONICLE - Toa Tahu Flame Sword
Replies
4
Views
514
ZadeWilson
ZadeWilson
Back
Top