Spiderman Webshooters from Civil War

Thread starter Vicracwil
Start date Jun 5, 2016

Vicracwil

New Member

Jun 5, 2016

I've got these 3D printed webshooters made for a cosplay, but I'm unsure how to get them to stay around my wrists. I'm new to cosplay and I've never used magnets. I've got a band made up to wrap around via velcro but it isn't very effective.

Any ideas, I don't want to send too much and i was thinking setting like magnetic watch bands but I've got no clue where to get those.

Here is an image:
http://m.imgur.com/gallery/aJAFhi8
It has two holes on either side for straps and is about hand size

Last edited: Jun 5, 2016

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.