Hello all,
I've been looking for a way to contribute to the list of great EP 7 replicas that are being done by everyone and I finally found the first one I'm going to do.
Rey's blaster. The one Han gives her... that she shoots at Kylo Ren with.
This is a semi-hollow kit with moving trigger and moving safety. I also believe it's the most accurate replica anyone has done to date, including in how it goes together.
Cost is $235 shipped worldwide.
This will be a limited run so as not to compete with any official products in the pipeline. Current lead-time is estimated at 2-4 weeks to ship after payment and I am accepting orders ongoing. Each kit takes about 40 hours in high-res print time, not counting setups and machine cleaning, spread over several days so i can sometimes get backlogged. (Normally, the cost of this type of print would be $8-10 per print hour.)
For those that don't know my previous work, click the image in my sig.
Here are some images of the near-final pattern. (Note: I didn't clean all the parts of flash, so the trigger guard looks a little thicker than it is.) The kit can be mainly screwed together but a little glue will be needed. (I recommend solvent-based acrylic glue such as Acrifix 116, but superglue works as well.) Torx screws (M4 or imperial equivalents) are not included since I can't get a large supply and the US/EU have different systems anyway. The barrel will have an aluminum insert for strength. The kit includes the parts shown in the breakdown photo.
Latest photos:
Quick assembly and paint test.
Latest renders:
Drop me a PM or state here if you want one.
Thanks!
I've been looking for a way to contribute to the list of great EP 7 replicas that are being done by everyone and I finally found the first one I'm going to do.
Rey's blaster. The one Han gives her... that she shoots at Kylo Ren with.
This is a semi-hollow kit with moving trigger and moving safety. I also believe it's the most accurate replica anyone has done to date, including in how it goes together.
Cost is $235 shipped worldwide.
This will be a limited run so as not to compete with any official products in the pipeline. Current lead-time is estimated at 2-4 weeks to ship after payment and I am accepting orders ongoing. Each kit takes about 40 hours in high-res print time, not counting setups and machine cleaning, spread over several days so i can sometimes get backlogged. (Normally, the cost of this type of print would be $8-10 per print hour.)
For those that don't know my previous work, click the image in my sig.
Here are some images of the near-final pattern. (Note: I didn't clean all the parts of flash, so the trigger guard looks a little thicker than it is.) The kit can be mainly screwed together but a little glue will be needed. (I recommend solvent-based acrylic glue such as Acrifix 116, but superglue works as well.) Torx screws (M4 or imperial equivalents) are not included since I can't get a large supply and the US/EU have different systems anyway. The barrel will have an aluminum insert for strength. The kit includes the parts shown in the breakdown photo.
Latest photos:
Quick assembly and paint test.
Latest renders:
Drop me a PM or state here if you want one.
Thanks!
Last edited: