Removing silicone caulk?

SgtFang

Sr Member
Gone but not forgotten.
Hey guys, I've got something here I need to mold in a hurry, but there's a couple areas where something was attached with clear silicone caulk.

Most of it has pulled away without a hassle, but some bits down in a groove are being pretty stubborn.

Anyone have any ideas how I can remove it w/o damaging the paint job?

Thanks!

-Sarge
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top