Sizing latex mask on foam head

Thread starter ERen89
Start date Oct 1, 2015

ERen89

Active Member

Oct 1, 2015

So my approach will be making a mask from liquid latex, last year I applied it to panty hose material which worked very well. But I'm going to get a foam head from hobby lobby but those are way smaller than my own head. What's a good way to bulk it up to the proper size and a material that won't get insanely messy when I start to apply the latex and won't seep through the panty hose material and stick permanently to the head?

Last edited: Oct 1, 2015

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.