gmrhodes13
New Member
Got one of these Nerf sidearm's and even though they are quite small I thought I would give it an upgrade, I like my blasters to have light and sound 
First I'll take the sound electronics from an old $5 blaster
Sand off some of the raised writing
I've got some nice rectangle lights to go in the side, I think it will have them but nothing is sure until the movie comes out.
Fitted
Now to find some room batteries, rear compartment looks nice
Fitting in the rest of the electronics, jack to run to an amp and a high bright blue LED, who knows what colour it will be
Everything in and time to for a test.
Decided to change the flash hider as it just looks too small. I looked at using the hider from a Rubies DL-44 but it was too big, then I found an old plastic funnel tip.
Cut down to size and holes drawn
Drilled and fitted
Also trimmed down the trigger a little
Example blaster
Primer applied, sanded and then a coat of black
Masked and first coat of white applied
And done
First I'll take the sound electronics from an old $5 blaster
Sand off some of the raised writing
I've got some nice rectangle lights to go in the side, I think it will have them but nothing is sure until the movie comes out.
Fitted
Now to find some room batteries, rear compartment looks nice
Fitting in the rest of the electronics, jack to run to an amp and a high bright blue LED, who knows what colour it will be
Everything in and time to for a test.
Decided to change the flash hider as it just looks too small. I looked at using the hider from a Rubies DL-44 but it was too big, then I found an old plastic funnel tip.
Cut down to size and holes drawn
Drilled and fitted
Also trimmed down the trigger a little
Example blaster
Primer applied, sanded and then a coat of black
Masked and first coat of white applied
And done
Attachments
Last edited by a moderator:
