I am filling out a trek case and was wondering how to go about cutting the gray foam. I was thinking of using a bread knife in a sawing motion, or even a small hand saw or jig saw. I was also thinking that pressing the foam down tight in a cutting press of sorts and using a knife would work, but the cut would be angled or rounded right; from the compressed foam not being pressed down evenly?
I'd like to stay away from expensive cutters or rigs. Just stuff I can get for $20 or less and jg it up if I have to.
How do I do it?
I'd like to stay away from expensive cutters or rigs. Just stuff I can get for $20 or less and jg it up if I have to.
How do I do it?
Last edited by a moderator: