Need help with cutting foam on the cheep.

Sulla

Sr Member
RPF PREMIUM MEMBER
I am filling out a trek case and was wondering how to go about cutting the gray foam. I was thinking of using a bread knife in a sawing motion, or even a small hand saw or jig saw. I was also thinking that pressing the foam down tight in a cutting press of sorts and using a knife would work, but the cut would be angled or rounded right; from the compressed foam not being pressed down evenly?

I'd like to stay away from expensive cutters or rigs. Just stuff I can get for $20 or less and jg it up if I have to. :)

How do I do it?
 
Last edited by a moderator:
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top