This is a lifesize figure project that I've been wanting to complete for a very long time. Been busy collecting pieces for my Gonk droid project (damn you Fuzzual!) and finishing my Death Star Hangar room, but I finally found some time to work on this. I haven't airbrushed much, bought one a few years ago when I started my Luke X-wing and haven't used it a ton, so I'm still getting use to it.
I bought a mannequin off eBay and removed the head. I went with a smaller mannequin that was about 5'10" to try and stay close to Alec's original height. Unfortunately he is a bit slim, but I'm going to bulk his sides up with some foam. Once he's dressed I don't think you'll notice. His head is also disproportionate compared to the rest of the body, but again I think that will be hidden once he's dressed.


Removed the eyes and started airbrushing the flesh tone.

I got most of the base coats on and did a little highlighting. I bought some fake eyes and installed those as well.




I still have some detailing to finish up then I can mount this to the mannequin body.
I'm looking forward to adding this to my Death Star Hangar room!
I bought a mannequin off eBay and removed the head. I went with a smaller mannequin that was about 5'10" to try and stay close to Alec's original height. Unfortunately he is a bit slim, but I'm going to bulk his sides up with some foam. Once he's dressed I don't think you'll notice. His head is also disproportionate compared to the rest of the body, but again I think that will be hidden once he's dressed.


Removed the eyes and started airbrushing the flesh tone.

I got most of the base coats on and did a little highlighting. I bought some fake eyes and installed those as well.




I still have some detailing to finish up then I can mount this to the mannequin body.
I'm looking forward to adding this to my Death Star Hangar room!
Last edited: