Useful for IG-88 barrel?

Andymac84

Sr Member

• Jun 30, 2015

• #1

Would this part be of use for a builder? I've rescued that piece from getting into the trash, because the look was so familar. So a quick search was getting me reminded. Maybe somebody can use this for a IG-88 BlasTech DLT-20A blaster rifle. Holes are pre-drilled, the diameter is about 10cm, and the length is around 70cm. Can take closer measurements. Sorry for the mess in the pics.

 

OdiWan72

Master Member

RPF PREMIUM MEMBER

• Jun 30, 2015

• #2

Would make a nice part for a scratchbuild, but it´s way to big for the IG88 blaster. its barrel jacket has a 45mm O.D. IIRC

Where did you get it from/ what´s the source of that part?

Markus

 

Andymac84

Sr Member

• Jun 30, 2015

• #3

Too bad..
Don't know exactly what it is. I think its a barrel which was running a filter within a machine.

 

TazMan2000

Master Member

• Jun 30, 2015

• #4

At work we use something similar on our technical drawing printers that pick up waste toner. It is too large of a diameter for a barrel jacket as well.

TazMan2000