rockeagle2001
Well-Known Member
Is this just a paper unfold?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
The HD version? I cant give that version away due to licensing. there is a printable version you can get for a toy tho.hi @Shadeling
i have interest in a 3d printable version of this. obviously not AS big as hulkbuster...but some scalable version of this.
that is sad @Shadeling. licensing is always an issue for everything in life...not even just for say the gauntlet and the helmet?instead of the whole thing?
Springs are danger for health... :unsure maybe you can put them in some tubes... just in case:thumbsupOnce the design is complete I'll be happy to post up all the framing and gears as such that I make. The shoulder/arm skeleton is going to be mostly PVC pipe with bolt on swivels for joints. The shell and hands will be printed (fingers crossed) with smooth cast brushed on.
Magnet snap together connectors for the LEDs and cooling fans that are not mounted on the chest, 1-2 stepper motors for the helmet, and a few springs in the lower leg area.
50% done on the chest... BTW, seems like there's a piece missing behind the tummy part, under the chest part and above the COD part, I hope I'm wrong but that seems to be the case.
And I'll have to ake a pause because of work and family stuff. I'll get back to work next month. Shadeling, you have no idea how happy my son is. Thank you so much!
Yes please! I don't mind but my son would be very thankful!I cant wait to see it. the blank section didn't have much. I left it open for better flexibility, there isn't much to that section to be honest. I can pop it out and unfold it if you like.
View attachment 498931 View attachment 498932
Damn that was fast! Thank you so much!Lower Back added to first post
3D print dry run for size and cost to print. My printer can print up to 10" squared
View attachment 499552
Very nice! I'm super jealous, I really wish I had a 3D printer :cry
it's pretty much an open source item. I've upgraded almost all of it at the same time and I'm still chasing a voltage issue in the extruder. I've come close to pitching it a few times