TMNT Shredder Costume. (Already finished)

MrPinski

Sr Member
So I started out last year making a helmet because I had always wanted one: http://www.therpf.com/f9/tmnt-shred...-but-i-made-my-way-221837/?highlight=mrpinski

I then decided to make the whole fit. The helmet wasn't exactly built to SA specs, so I figured that I would do something a bit different with the rest of the costume as well.

The armor is made on a Worbla base, covered in leather, trimmed in ABS and resin cast bladed that are pop riveted in place.

The whole build I documented on my Flickr: https://www.flickr.com/photos/mrpinski/sets/72157649437515613/

This is the finished product. I hope you like it, I also hope you give feedback where it's needed. I plan on wearing it to ComicCon in San Diego this year so I would love to improve it if you think I need to.

Untitled by MrPinski1, on Flickr
Untitled by MrPinski1, on Flickr
 
Yea I would totally start stealing TVs and VCRs for you. Awesome work!


Sent from my iPhone using Tapatalk
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top