johnojodo
Active Member
Hi all! I'm Ed and I'm starting a part Judge build (Helmet and belt kit)
Had a crack at the door breaching mine over the past couple of days, started with a 50mm resin blank but I wasn't happy with the results so I tried with nylon rod on my wood lathe
Still not happy with the outcome as its about 3mm to small, but its a start
Still needs painting, I used some brass filler in the resin to help see the lines when I'm cutting and sanding.
This is an evolving prop and I'm only on v2 I'm gonna look around for some washers/discs of the right size to tidy up the top/trigger section
Had a crack at the door breaching mine over the past couple of days, started with a 50mm resin blank but I wasn't happy with the results so I tried with nylon rod on my wood lathe
Still not happy with the outcome as its about 3mm to small, but its a start
Still needs painting, I used some brass filler in the resin to help see the lines when I'm cutting and sanding.
This is an evolving prop and I'm only on v2 I'm gonna look around for some washers/discs of the right size to tidy up the top/trigger section
Attachments
Last edited: