Degassing Vacuum Pump?

Downfall

Downfall

Well-Known Member
RPF PREMIUM MEMBER
Im just wondering if the specs of this vacuum pump would be good enough to use for degassing silicone?
The chamber I have is 24 Litres in size.

20150206_131920_resized.jpg
 
It should work fine. It may take a little while for it to reach full vacuum. It will probably take minute to suck all the air out, but unless you need it to be more rapid, it should be fine.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

wisemonk5421
Vacuum forming clear petg
Replies
0
Views
304
wisemonk5421
wisemonk5421
Kaito3Designs
Advice on creating resin molds for vacuum forming. Replica Phantom of the Opera mask
Replies
2
Views
507
Mr Mold Maker
Mr Mold Maker
mhariush
$299 Vacuum former? VacuumSnap Ultimate Desktop Vacuum Former
Replies
19
Views
2,620
mhariush
mhariush
D
Vacuum Forming Orange Peel
Replies
3
Views
922
T R A V I S
T R A V I S
Palantirion
A Pumpkinhead one-off, build thread (pic HEAVY!)
2
Replies
28
Views
1,423
Palantirion
Palantirion
Back
Top