Pip-Boy 3000 Build

Olsalt

New Member
Hey everyone I've decided to post some pictures of my first decent prop build. After lurking on the forums on here for a few years and recently acquiring a 3D printer I decided to give a shot at the prop I have wanted the longest, the Pip-Boy 3000. here are some pictures of it. I 3D printed this off of dragonators files he posted on the thingiverse that I think have since been either moved or removed. I did some weathering by putting some silver spray paint on a nail file then scratching it up to give it a worn metal look. The screen is paper with some plastic report cover things to add the terminal green look. The electronics are just green LED light strips I bought at the auto store. I still need to put in the Geiger counter dial, the orange LEDs, and I also need to start the glove. Some thoughts or tips would be apreciated. Also a thanks to Droderic for helping me with the screen.
20150330_102210.jpg.20150331_185636 (1).jpgphoto_1427557938051.jpg20150330_102200.jpg20150330_102136.jpg20150330_102144.jpg
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top