Carving Foam- Pattern application help

Jut780

New Member
Hey guys, new to the forum and website...

I have been shaped indoor rock climbing holds for various commercial indoor climbing hold companies as a side hobby and had a question related to some detailing that some other companies have been using.

Has anyone seen a dremel bit or other tool that could create symmetrical patterns like that shown in the picture below? Thanks in advance!
 

Attachments

  • bubble-wrap-001.jpg
    bubble-wrap-001.jpg
    202 KB · Views: 194
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top