Deleted post

That looks absolutely perfect, but unfortunately the YouTube compression makes the spinning blades very hard to make out till the shot gets close.

How and where did you frost the domes? Inside and out, just one side, just the outer one, both? Steel wool, fine sandpaper, matte spray?

Paint -- Tamiya clear orange, Liquitex transparent inks, something else?

Thanks. :)
 
WOW.

You've crossed over into too good. If you washed out the domes a bit in post and added ridiculous amounts of grain and contrast, you'd have a genuine shot from TOS.

Just amazing. And that pisses me off. Stop doing that. :p
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

JimmyB
'THE Model Railroad Hobbyist’s Guide to acrylic painting ... in a post-Floquil world' (pdf)
Replies
2
Views
312
JimmyB
JimmyB
S
Accidental double post - please delete
Replies
1
Views
316
JPH
JPH
MARK M3
DELETED.
Replies
6
Views
649
MARK M3
MARK M3
TazMan2000
Post pics of your own 3D creations (not purchased)
15 16 17
Replies
335
Views
29,897
TazMan2000
TazMan2000
C
Deleted.
Replies
5
Views
2,319
compucrap
C
Back
Top