newbie needed some advise

J

Joshwood

New Member
#1​
New to this looking to find something to occupy my time while its both cold and between night shifts what's the best foam to use when using the foam patterns got some 1/2 inch foam pva glue and a lot of cutting equipment any advise about better foam to use on both the helmets and the armor itself seen some amazing stuff on here loads of inperation​
 
Last edited by a moderator:
Hi Joshwood ... welcome aboard ... I think it would become a lot easier if you explain which helmet and armor you're talking about so then you'll attract the right crowd to come to your aid ;) Then there's also the 'popular franchise' section perhaps you meant to post your inquiry there? And if you mention your character in the title ... you'll get the picture, right :)

Chaim
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

TomVDJ
Identification needed of prop replica "accessories"
Replies
2
Views
211
TomVDJ
TomVDJ
Cmdr.Kerner
Some more Starfleet PADDs
Replies
3
Views
530
Cmdr.Kerner
Cmdr.Kerner
Feltman Langer
Advise Needed: Glue for PLA Prints
Replies
12
Views
1,100
Skyler101
Skyler101
LimeyBuilds
Is this a found object fire proof bag of some sort?
Replies
8
Views
601
drusselmeyer
drusselmeyer
ItalianNinja86
Blade Runner tomenosuke blaster minor question/help needed
Replies
5
Views
942
robotprops
robotprops
Back
Top