Clone Helmet - Phase 1 or Phase 2?

Thread starter Aethon
Start date Nov 30, 2014

Aethon

New Member

Nov 30, 2014

I've been thinking about making a cardboard Clone trooper helmet, but I'm unsure whether to make a Phase 1 or Phase 2 helmet (or maybe even a different helmet like the Airborne helmet, Scout trooper helmet, etc.) Which one do you guys think would be easier to make? Any good templates out there? Thanks in advance.

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.