Repairing chip in textured paint?

SiGeCore

New Member
I achieved this texture/paint using Rustoleum gray primer, followed by Rustoleum Cold Galvinizing Compound, followed by a few coast of Rustoleum Clear Coat, and lastly Silver Leaf RubNBuff. The base itself is Sintra. Is there a way to fix and reinforce these chips without having to completely sand and repaint?

IMG_20141119_005050[1].jpg
 
You try to patch paint but it will probably show where you touched it up.
I think you will need to repaint to get the best results.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top