3D Printed Samus Phazon Suit ( Pic Heavy)

Sundayy

New Member
Thought I would finally actually post my build here. Suit is 90% 3D printed, only thing not 3d printed were the abdominals. Made up from 300+ parts printed on an UP Plus 2, using 6-7kgs of filament. Included a detailed bit of the shoulder connection since shoulders connections are generally a point of interest and costumers woes. Worn at dragon con earlier this year.


10603306_567589070019800_7823575257195194628_n.jpg
samus-3d-models.jpg
samus-helmet.jpg
samus-chest.jpg
samus-shoulder.jpg
Universal_Joint.jpg
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top