Okay, here's what you'll get in the kit - do a parts inventory.
Everything associated with the body:
2x for the guns:
4x for the wings:
4x for the engines, and one set of the new-to-this-kit wing inner-hinges
Preliminary things.
First ensure the supplied hinge assembly fits and operates within the body halves. You will need to sand the hinge halves themselves, and possibly trim the BOTTOM hull recess:
When done, they will close:
And open!
Aluminum bar will sit flush against the rear, which will allow the buttplate to fit.
As you can see, the wings will fit nicely against the L brackets!
Oh! There are also four of these plant-ons that fit inside the wing's edges (I'll show that later)... I dropped a wing and a chip blew out, so I'll fix that with Apoxie Sculpt shortly. Things happen when you build, so relax - everything can be fixed.
I'll also show how you can add the metal armature, which will require a little routing of the front inner hull, from where the landing gear box was in a previous version. More on that later. You won't need to do this at all if you stick with the resin/metal armature as seen above.
Things to note - you will need to clean up and rescribe some panel lines. I'll do that next.
Also, you will need to remove some material from either the inner upper hull or the cockpit insert to get it to fit as high up as you see on the ILM birds. That will also be next: