My 1/6 Lost in Space Robot Build

MARK M3

Master Member
RPF PREMIUM MEMBER
My Moebius Models 1/6 Lost in Space Robot build. I used brass and aluminum tubing to strengthen the connecting points of the treads and lower torso. I also made the model easy to disassemble to add more electronics, including the voice box/light and ambient sounds. I will do this at a later date, as well as replacing the bubble (I don't like the seam) and Lighting the Bubble. His upper torso and Head can be manually rotated. The batteries are hidden in the tread section as is the switch.







 
WOW...Mark...had no idea...this was all you.....I contacted you recently from FB model sites.....didn't know you were here all along.....that's awesome work Mark !!!...Love the B-9 robot !!! Guy Young
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top