I have had this mini case laying around for ages, and always wanted to do something cool with it. This is just a rough build, but as soons as i get more foam I will be making a better looking laserbeak.
I used EVA foam, knitting needles and empty till receipt rolls.
Thanks guys, yes I just googled a picture of laserbeak in the cassette form, I then measured the inside of the case I had, drew the rectangle and then drew all the separate lines, cut it out and went from there.
Thought I would post an update of these trans'foam'ers.
I did a small run of these as they were very popular. I still have some outstanding orders to fill. I made them a little thinner by removing the third foam layer, I also had to make the head flip out instead of slide out.