daredevil665
Sr Member
Hello everyone. With this new thread starts a new replica of the ALIEN HR Giger version. This time I will try to be more technical than the previous ALIEN built by me. This new alien will have a trellis that runs the full height, which will allow you to mount / unmount ALIEN, legs, torso, arms, head, tail, rear tubes. Some of these parts will be assembled by means of magnets. I'm still undecided on the height. The original should be around 233 cm, but I'd like to get about 260 cm. It will support on a wooden base with a thickness of only 2 cm, with the ability to add wheels. The previous base was 20.5cm high. The pose will be like the one on display at the museum, because other poses that I had suggested in the previous thread are bulky and, in my humble opinion, less disturbing.
This new sculpture will be more faithful to the original, with regard to the proportions, with head and feet large, and hamstring deflated. The fill volume will be polystyrene, coated with clay / cellulose-based that air dries.
To align the model to the original, I used this picture, I had to change by turning the chest and head, because it seems that these original parts are a bit 'drooping toward the rear.
To be continued.
This new sculpture will be more faithful to the original, with regard to the proportions, with head and feet large, and hamstring deflated. The fill volume will be polystyrene, coated with clay / cellulose-based that air dries.
To align the model to the original, I used this picture, I had to change by turning the chest and head, because it seems that these original parts are a bit 'drooping toward the rear.
To be continued.
Last edited by a moderator: