Gauntlet building help.

Thread starter Wast3land
Start date Jun 17, 2014

Wast3land

New Member

Jun 17, 2014

I printed the gauntlet templates from wof on construction paper and assembled them. What is the best resin to harden it on said construction paper or cardboard? Thanks.

This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.