The Infamous GOLD PLATING / CHROMING topic...

Yellow pages, man. I found a guy here in Omaha that will do some work pretty cheap. Best thing to do is just look around in your local area, and price match. It takes little time an patience but its well worth it.
 
I've been saying for the last 6 years, that someone here needs to get a good set-up from Caswell Plating and become the official board "plater", but so far no one's rose to the occasion. Heh, they'd be rich about 5 minutes later... :D

-Sarge
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top