Blue Beetle Costume - Getting Silicone to stick to Fabric

dcurtis

New Member
Hello all,
I am about to start work on my first cosplay outfit. I have decided to do Jaime Reyes version of Blue Beetle (see links below). I have done a little research on this but not enough to fully understand all the the tricks of the trade. Basically, I would like to use a Zentai suit as the under layer of the costume. I was then going to create the blue parts of the mask w/ silicone and hopefully somehow attach the strips to the suit somehow. Only problem is that silicone normally doesn't play nicely w/ others. Are there any tips/tricks others have used for this? Thanks!

http://th05.deviantart.net/fs70/PRE/...13-d3a6gdd.png
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top