Hardboard and Silicone

I'm not totally sure ctown but I would think it would not be a problem. I've used epoxies and resins on hardboard and they dried/cured fine.

My bet is it should cure fine. Perhaps try and test and see if you can. Always a good idea before large scale attempts.

Jon
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top