Daft Punk: Guy helmet build!

Sebastein

New Member
So I am a teacher's assistant at the Art Institute of Pittsburgh in the Entertainment Design program for the CNC milling classes. And as a side project for myself, while showing other students how to used the CNC milling machines i decided to make my own Guy helmet from Daft Punk! The project was milled out in two parts, glued together and then covered in wood glue to seal everything in because i used insulation foam. I am on the bondo and sanding step now and will post progress of that as time passes. I will be finishing the helmet, molding, casting and painting by the end of March!

IMG_2487.JPGIMG_2488.JPGIMG_2489.JPGIMG_2490.JPGIMG_2491.JPGIMG_2492.JPGIMG_2493.JPGIMG_2494.JPGIMG_2495.JPG
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top