11th Doctor sonic- emitter

CaptChunkyChew

Well-Known Member
Hey all! ive been a member for a while, but this is my first thread! not actually sure if it belongs here, but anyway, a question.
i really want to try my hand at an 11th doctor screwdriver, and have got a mechanism all worked out, but a question about the emitter. i know how to cast it, but i don't know how to get the swirly, marbled look that the emitter has! any ideas would be much appreciated, and as soon as i get started, i will do a thread diary!
 
thanks, i have seen your build thread, and yours is looking, if i may say so, swagalicious! seriously, mine will not be in metal, wood, plastic and resin where possible! quick question, are you using a white or green LED? because i think i have found the reason why it looks turquoise-y in series 7b, they changed the LED from green to white.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top